NUMERICAL MODELING OF CENTRIFUGE TEST PROCEDURE FOR DIFFERENT EMBANKMENT CASES
Keywords:
Finite Element Simulation, Centrifuge Test, Reinforced Embankment, geosyntheticsAbstract
Physical modelling through full-scale and small-scale models is widely implemented in order to
define specific aspects of the prototype behaviour. On the other hand, numerical modeling is essentially required
to cope with the complex geotechnical problems due to the ability of considering and analyzing all aspects of the
model and can afford more perception about the behavior of structures such as geosynthetic-reinforced
embankments. In this study, four different cases of unreinforced and reinforced embankment models constructed
on soft and stiff grounds were studied. Small-scale physical modelling by means of centrifuge tests and numerical
modelling by means of finite element simulations were performed. As the small-scale model was rotated in
different acceleration fields during the centrifuge test, the dimensions of the centrifugal model were different from
the original state of the prototype in different stages of the test. This paper focused on developing a finite element
simulation based on the dimensions of a centrifugal model in different incremental acceleration fields applied
during the stages of the test. Comparing the results of finite element simulations with the measurements of the
centrifuge tests showed a good agreement between the two methods, which verified the reasonableness of the finite
element models in analysis of embankments based on small-scale centrifugal dimensions. Moreover, the results
showed the different deformation behaviour for embankments on soft and stiff grounds and indicated the
significant effect of the geosyntheic reinforcement on increasing the stability of the embankment on soft ground.